Recent content by tango232

heating controls are slightly different to the weapons systems I normally wire up :lol:

well for the first time in a year. I can put the hot water on and the valve stays in hot water. if i put heating on only the valve goes to the heating position. and if I want both then it goes to the middle position. :o the boiler has not gone out on overheat yet so it is looking good...

just re wired it and trying it out now to see if it trips out

so just to check what I am doing. I have two neutrals from the boiler so I can stick them both into jct 2 the live from the boiler needs to go to the perm live on jct 1 rather than jct 7 as shown on the drawings. the SL from the boiler into jct 7 put P from the boiler and the pump...

Hi Kev that is the wiring diagram i have for my boiler, just not sure where to wire them in the junction box. this is the way i have wired my system. http://www.draytoncontrols.co.uk/uploadedFiles/Drayton/Applications/MidPositionControlSystemLWC3.pdf [/img]

I have had a few problems with my system and have replaced the pump, mid position valve and controler over the last year. i wired them all back up with the diagrams that i was given when i got the house. this cause me an issue where I could not get the mid position valve into the mid position...