Recent content by tap washer

It was the control unit and the ignition unit both GOOSED now replaced £160.00 boiler working again. :lol: :D :D :D

Will do tommorow, I will post diagnosis

Enough oil in tank watchman says 3 like I say the boiler is not locking out which it did once years ago when we ran out of oil (blockades) remember them?

We have a worschester heatslave 20/25 the fan runs but no oil is present at the injector the boiler has not gone into lockout there is oil present at the supply pipe (silver braided flexi) is it a control unit, is oilman there?? :cry: it is getting cold, is there an easy fix for tonight?? :roll:

Elecctrician has had the first one up to its limit, the second one is factory set at 60 degrees which should be hot enough, but the problem persists :cry:

So why do cylinders have only one immersion plug formed at the top and none anywhere else.

The cylinder (or the water in it) was previously heated by a solid fuel back boiler (old). The boiler burst, the pipes to the boiler were capped off, an immersion heater was purchased and installed, (new). Problem as previous heating only quarter of a tank of water (wet) :roll:

thermostat is fixed in the centre of the element??

I have installed a 30" immersion in a direct cylinder that was previously heated by solid fuel the cylinder only part heats i.e. only the top quarter gets hot. We have tried 2 immersion heaters both give the same result? :roll: :?