Recent content by tech

Grrrrrrrrrrrrr sludge *

:evil:

Time control - faulty :roll: Honeywell time control ? Is the system correctly wired .?here quick check : Set dhw and ch to 24hrs , turn down dhw stat min -turn down ch stat min , Boiler-pump should now be off . turn up ch stat max -boiler pump on *turn off stat boiler+pump off...

Building reg L = Benchmark :idea:

system bypass ? :roll:

try balance both the radiators i would think the radiator above is linked too one below try forcing the water down into this radiator by reducing the flow into upstairs radiator , I assume you don't have thermostatic radiator valves installed - on either radiators ?

so true * :?:

Over heat stops your boiler from ,transforming into a pressure cooker * if the main boiler stat fails or is wrongly located within the boiler. all sealed systems must have a overheat safety device , *

don't Diy : Get the system checked by a corgi engineer you could save yourself £,s in the long term . *The pump turns on when i turn on the boiler stat* :? :?

dont DIY

On the msv actuater there is a leaver ,push the leaver over too one side there will be some resistance ,move the leaver in a upwards direction . Push the leaver into the recess position located on the valve.

manually override the msv actuater ,

I know the fault but it is going too cost ---

Ep 2000 grrrrrrrrrrrr Did you find the pump ? above the pump should be one or two valves is there ?

possible that your diverter or zone valve is at fault , you do have your room thermostat turned too max!!! ?