Recent content by tedsvokera

thanks for the info, much appreciated :wink: Ed

does it matter which way round the A and B go or will any way be ok? Ed

Hi guys, i have bought a programmable wireless room thermostat and i am trying to wire it to my vokera linea 28 combi boiler THR872CUK is the model of the programmer. i have got a mechanical timer at the moment but hopefully the new one will save me money...

the motor is working fine but if the temp only goes up to 41 degrees (sometimes) and i remove the motor, push the push rod in and out three or four times then refit the motor the temp goes up to 48 degrees no problem :?: if i restrict the flow of the hot tap the temp goes up to 58 degrees...

spoke too soon. when the central heating is off and i turn the hot tap on, the central heating flow pipe heats up? in the service kit there was a black diaphram type bit of rubber about 40mm diameter, anyone know where it goes? what is the maximun temp i would expect to see on the digital...

problem solved. diverter valve service kit :D best news all week. thanks for all your help eddie

thanks tony i would say yes to the gas readings etc but i have never touched the boiler, my main stop valve is downstairs under the sink all i done was switch it off, drain the DHW, blank 2 pipes in my bathroom then refill the system, then there was the problem, could there be a bit of crap...

tony the temp goes down if i turn the control knob down. if i turn the hot tap on full the temp only goes to 41 degrees at the most but if i slow the flow out of the tap the temp goes up to 47 dregrees? it seemed to be working fine last night then today its playing up again. could it be the...

i only turned the stopcock off under the kitchen sink, drained through the taps then re-filled the system thats when the problem started. could it be the domestic heat exchanger or some kind of sensor many thanks eddie

no ive checked that the temp is up as high as it will go on the control panel eddie

hi there hope someone can shed some light on my problem. i drained my hot water system to fit new bathroom suite, when i filled the system back up the boiler will only go to 41 degrees on the display and it stays at this constantly. the heating is working perfectly the hot water pressure is as...