Recent content by thenuke10

Not sure. I used 183 m3 over the same period. That was in a 3 bed bungalow that was built 20 years ago. Boiler 440cdi condenser. Heating and hot water. I would have thought it depends on property and where in the country you are plus how warm you like to be.

We've been using Dairy bleach for a couple of years now. Costs about £15 for about 25litres. Mix it 10 to 1 with water. Works a treat. I just leave it on, don't wash off. Just be careful by the flower beds. Get it from a farm supplies.

Billy see ebay link above regards :lol:

you are welcome have a nice day

Yes simple job 2 men. or 1 man and 1 wife I Took all screws out. You might not have to It is just a matter of pushing bracket into glider, screwing channel back regards

If it is like mine the white bit of the channel clips off, Try a Knife. Once you get it started it is easy. Once off there should be holes on the opposite side of the channel. hope that helps[/b]

Had the same problem got these http://www.ebay.co.uk/itm/120842227143?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1497.l2649#ht_922wt_1165 hope that helps

thanks guys thought as much.

Hi Can someone tell what is specific/different with a Macfit pan connector thanks guys

Thanks Just looked at the boiler manual, It's plug ST10 not ST20. Also I am using volt free therefore I am not using the neutral, I have connected as follows Ls boiler to Com thermostat, Lr boiler to N/O thermostat, Everything seems to be working fine. I am just asking to put my mined at rest...

Anybody confirm I am right or wrong

Guys Just after some advice, Just connected a wireless Danfoss TP5000si to the above boiler. Can someone just confirm I connected it right. Removed link from Plug in boiler (Off top of my head Plug ST20) Ls and Lr and connected Common in Thermostat to Ls and N/O in thermostat to Lr. Thanks

hi, some assistance would be appreciated, about to buy a wireless room thermostat to pair with a WB greenstar 440 cdi. Is there anything specific I need to look for. Was looking at some Danfoss and honywell ones. regards

Hi guys After some advice, have the above boiler but require to do some central heating pipework mods over a couple of days. Is it ok to isolate the central heating side on the service valves Flow/Return on the boiler but continue using the hot water. Obviously if I break into the CH pipework...

the size that fits into the monobloc tap.