Thanks for the reply. I think you could be right. I'll have to get the ladders out! I did a search on the bell box and found 1 person who had similar problem after 4 years. But on the whole it seems these bell boxes cause little problems.
Well I just spoke to some of my other neighbours and it did go off.
So I come to my earlier question, if a fault occurred and then rectified itself would it still be recorded in the log?
Alarm activation but nothing in log!??!?
:?
It is wired correctly. As you rightly say lifting off the front cover triggers a tamper activation. As does trying to remove the backplate from the wall.
However, when this occurs it is recorded on the log and requires a reset before the alarm can be put into 'run' mode.
This is what...
Yes of course, I'd forgotten the bellbox has its own battery backup.
Is there a way to provide power for the battery backup other than from within the bellbox itself?
Since I do not have any concrete information to go on, and my only guess is that it could be related to the tamper for the...
If I were to open the accenta panel, remove the 2x tamper wires for the bellbox and temporarily join them together, then add a link on the pcb board (where i'd just removed the wires from) between the 2x tamper connection would that disable the tamper for the bellbox?
This way I could get to...
Given that the bellboxes are not water tight and therefore that well protected from the elements do they go wrong often due to weather conditions i.e. cold rain etc?
I have an Accenta G4 and whilst out shopping for a short while and with the alarm not set the alarm apparently activated.
My neighbour only told me 3 days later so I looked in the logs and there is record of an activation.
I remember that I had some issues with the bellhouse tamper when I...