Recent content by ToAoB

If you can advise where I can get a heavy duty one that would be able to handle heavy lifting from please? I've had a look and not sure if any are up to the job.

Thanks all for the replies. The space I have to do this is very limited, probably about 1.5 feet to neighbours outbuilding! It's hard enough squeezing myself into that space in the first place! I think the z bracket may be the best choice with a car jack (will need to borrow one as just sold...

Hi, I have just noticed the brick supporting the wooden shed base has broken which resulted in the base being lowered. I don't have a car jack that would fit this low. I was wondering if there any useful tips on how to lift the base whilst putting in support underneath. There is concrete...

Update: part fitted, HW working but CH doesnt so new CH stat fitted and works. Issue?: For CH boiler does not fire up until a little while later (radiators heated up) and then off and then on a while later. When the timer delay PCB is bypassed, the boiler fires up immiedately but the micro...

I compared both 20/80 and the 24/96 installers manual - almost identical apart from the delay timer (and other items), makes me think perhaps the 24/96 main PCB has been previously fitted in the 20/80 boiler? Would this sound correct?

Yes it`s 20/80 as stated on inside the front cover. Glad you say its a great bolier - do you think its time for a replacement? I wonder what it would cost but I guess thats for another forum post! Thx

Thanks - have ordered from pcbs4u who are also on eBay. Will update once completed. Looking at Agile`s listing, I realised all I needed to do was search `Vokera 6759` which will produce better search results! Wish I did this before, but good to know this board still ever so reliable. Many...

The PCB you found, says it fit Vokera Flowmatic 24/96 RSE will it also fit the boiler model I have?

Engineer did speak to Vokera - they the ones that dont have the part anymore. Engineer works for BG and they only buy from manufacturers and no one else...so thanks Agile for finding this part, will go ahead and get this :)

When you say it`s been replaced by boards with fuses, will this still fit? Do you know if the boiler will accept a updated main board and its piggy backed fused PCBs etc?

Hi DP, thanks for the reply. If you have it, that be great, let me know if you find it as otherwise dont want to end up having to get a new boiler. BG says they will fit the part once a replacement PCB is found. In case you dont have the right PCB, what`s ther chances of finding a replacement...

Thanks here they are:

I have a service agreement with a provider who looks after the boiler however they are unable to obtain one part from Vokera as its no longer in stock. I have seen a photo of this part: a small PCB with components and a 4 pin connector. After reviewing the installers manual, the only 4-pin...

Where can i get the galvanised covering? How does the Denso tape works for protection? From where? The non drying paint - isnt it only applies to above 2m?If so it would not cover the vertical part of pipe...? Am hoping for something that makes it harder and bothersome for whoever tries...

why steel pipe how is it effective? Stronger? Surely there must be another way as not really keen on replacing the pipework seeing I just got it fixed.