Recent content by Tommy Newman

Hi thanks for the information. Where can I buy one of those PCB's? Is it possible to disconnect the alarm from the system to prevent the noise while I try a combination of codes?

Can I get the keypad up and running again? I'm guessing it doesn't know about the sensors anymore in the house? I have two sensors, one in the living room at the back door, and one in the hall way above the front door. I also have a panic button in the bedroom. Do I need to select the correct...

Hi, now the display is blank is there anything I can do to get back to showing the alarm status? I held down D, entered 2000 and did a clean start. What has that actually done then?

What can I do now? Did I do the wrong clean code, there is 2000, 2001, and 2002. Is there any way I can get the system back up and running again? Thanks for your help in advance

I thought it would do a clean start, reset the system.

I held down D and entered 2000, now the display stays blank and the alarm keeps going.

When I flip the rcd on for the alarm power, it starts going off straight away. How would I go about reprogramming it? Do I need additional hardware or is it resetting pins on the board or keypad number combination?

Hi, I was wondering if you could help me. I've had this exact alarm setup in my house. I have changed the code, and now the alarm goes off I cant disable it. I've tried my code, the master code 2222, and the engineer code 1111. I'm trying to work out what stores the code, I've taken the small...