Recent content by totalsolutions

Did you check one terminal to chassis, ( ground ) ? These things break down in different ways, melt down - fully open circuit or short to ground. This fault is not due to 1st time use, lower oven heaters are installed to cook food faster and better. You need to retest and test all elements and...

Hi Karla, Is the fridge / ice box fully frozen, if so you need to fully defrost first by turning off the power, after using up all the contents or storing in a friends fridge freezer and keep the doors ajar for at least 24 hrs. Keep an eye out for wet floors as any ice melts.

Water in a dishwasher is not clean, it passes through water pipes that bach fill with food debris and blocks the inlet / fill pipe line to the cabinet. You will need to pull off the water inlet hose inside the machine, take off the side panel and have a look. Hose in my d'washer are push fit and...

Open the door in mid wash cycle and look in the bottom at the water level, if low or very low you are washing with no water... Poor in from a jug, more water to just below the door seal and continue the wash cycle. Just gettin off train will be back

Google for manual, but as you suggest relay issues. Follow wires from ON heater to control pcb and relay. Should be easy and relay, may even have overheated / melted making visual identification easier. RS or Farnell for compoments. Be safe and disconnect power.

Just " repaired" a friends Indesit, poor spin and wet clothes...... turned out to be the transit bolts were still in place, well two of them the third had, over some 15 years knocked out a large hole in the rear cover. Being a little hard of hearing did not noticed any strange sounds.....Any way...

Panasonic Smart Home, new email sent to me Currys/PCWorld first looks may suit you.

gtrance, I hope you got a second opinion from your engineer saying the "gas" has gone. Logically the "gas" is present and is making ice cold contents. PS ok thread