Recent content by Toyle

Well I've already taped it all so... But before board goes ob i wanted to be sure I did an OK job. The tape seems solid and sticky.

Hi all, I have a stud wall with PIR insulation wedged inbetween batten. If use aluminium foul tape to tape up the joins between insulation and batten and the batten itself will this create an adequate vapour barrier? Cheers

Thanks cdbe. The problem with all that insulation is that it will make the height of the ceiling very low. Ideally I would like it at the same height or only loos upto 20mm. The other problem is that rafters are only 50mm (it's a small roof) so I would be able to place any insulation inbetween...

Cheers, got any insualtion advice? I need the thinnest most effective possible for the ceiling to.keep the height. I'm going to lower the bath by 10-15mm. I was looking at some bubble foilstuff from screw fix https://www.screwfix.com/p/ybs-airtec-double-reflective-foil-insulation-25-x-1-5m/50913...

Hi all, My bathroom sits under a pitched roof and is uninsulated throughout. I am planning to internally insulated the walls and ceiling. The purlins from my roof sit within the ceiling in my bathroom and reduce the head height in places (see photos). Is it possible to remove this purlins and...

Hi all, I am looking to internally insulate my bathroom. The bathroom sits above my kitchen under a pitched roof so the space is very limited (see pics). Construction is solid wall with lime plaster so I can chip off the old lime batten and insulate the walls. The problem I am having is the...