Recent content by turbo123

Heating up, first time in years.

Hi Terry, All sorted:), too much solder:oops:. Thanks

The Blockage starts at the bottom Red marker. Tried a screw nail but did not catch.

Terry, On straight bit of pipe, still above floor. Thanks

Thanks Terry, There is about 6" of pipework above the floor, it is laminate flooring that is down, so a bit of work to lift floorboards. Tried the magnet, found nothing. I then removed the pipe from the valve, and put a rod down the pipe, about 3" down it hit something like a blockage (just...

Can't see anything else in the cupboard with the Combi Boiler/ pipework, its a performa 28 Combi Boiler.

Terry New Rad came with a TRV and Lockshield, The side with the lockshield does not seem blocked, water flows okay on that side, I bled the Rad with this side open. there did not seem like any water flow on the side with the TRV as I could not bleed the Rad, so I fitted a standard on /off Rad...

Hi Guys, Replaced radiator in bedroom (upstairs, combi boiler also upstairs), could not bleed the old radiator as bleed screw was damaged, so radiator not worked for sometime. New radiator not heating up, I've bled the radiator, I've drained the system a few times to make sure no air locks...

Looks like it is failing, F1 – F2 – F3- F4 – F5 – F6 – F7

Ran diagnostics without failing (did not wash), Checked error code – now 7 flashes

Removed the circulating pump / motor and found piece of plastics that could have been stopping motor running, but when I put back together I now have error code 6 flashes – any ideas? Thanks, Turbo.

Hello, I have a Whirlpool ADG 7540 dishwasher with an error code 4 flashes. Cleaned filters and diaphragm switch. Does not run wash cycle Water drains ok. When the spray arm is removed (in wash cycle) you see the water pulsing up and down – about ½” to 1” Could the problem be...