Recent content by tvrjohn

Hi cdbe thanks for adding the images as it has clarified my concern with vapour barrier, so better to use OSB ok that seems a better solution. Regarding the cold bridging on the vertical studding, I had not considered that, is that really an issue to address ? Maybe I should read up on cold...

Hi CDBE thanks for writing about the insulation slabs, have now purchased 10 packs from B & Q a bargain. Was considering retaining them with a vapour barrier type sheet at the back in the cold / vented part of the loft space ? and plasterboard on the front

Hi Re-surrecting an unfinished project in an 1820s farmhouse where i submitted a Building Notice in Sept 2007 for a loft conversion to make it into two habitable rooms. How can i establish the spec for insulating beneath the rafters ? rafters only 3" x 2" so i will need 50mm air gap to start...

Hi folks, hope you can help me here dishwasher flooded at the base, when power button is pressed NO lights come on. Have pulled the machine out tonight, scooped the water out of the base tray, checked the fuse in the 3 pin plug all ok. checked anti-flood device, all bone dry smelled the motor...

gigz, Yes plenty of flow, just stops heating then cuts back in again

Hi Worcester 28CDI Combi, all works ok except that it won't deliver hot water constantly, flames stop and restarts after few seconds. What is the diagnosis please

Hi All have searched for this information without any success, could anyone inform me what the error diagnostic lights mean Please ? model is BDI631 Dishwasher 7 lights / program lights 1 & 2 solid lit, 3 & 5 flashing Thanks

could it be that i need to fit a diaphragm repair kit ?

Took the shower head off, then dismantled, surprised how many parts inside, anyway got it back together. It was all spotless, even the mesh filters :lol:

Ok shower head descale, shall look at that thanks

Thanks for your constructive comments guys will try what you suggested :D

The hot water to basins are fine, pressure throughout is good, even when shower goes hot / cold pressure remains the same, which is confusing. burner light goes on off, is it somethink to do with the big red vessel inside, which holds or balances the hot water ? thanks for any...

Was convinced the 15 yr old cartridge needed replacing to sort our shower temp problem. But it seems the worcester 28cdi is cutting in and out, whats the cure please ? THANKS

Hi Is this acceptable ? run 240v switched supply using 2 core cable to each GU10 connected in series using ? connector terminal blocks (choc blok) because the covered round terminal units are too large to go through the downlight apertures ? thanks

Hi Charger for my Ryobi 14.4v NiCad Drill has packed in. Can i use another charger i have ? Ryobi charger output was 18v 300mA Alternative charger output is 22v 450mA 9.9va - which was also for a 18v NiCad drill plugged it in and the charge light comes on, just concerned if it may...