Recent content by Tysonboy

Yes I had a good read through your post on this, very good but I noticed you isolated the CH flow and return from underneath the boiler, this is what I didn’t want to do just in case they don’t reseal, another person has told me to just isolate the cold water supply and drain using the two white...

Yes thanks for that, I have one of those

It doesn’t look a difficult job to do maybe a little awkward granted, but I’m a aircraft engineer and have fitted far worse and difficult components, was only asking for someone with experience of doing this work and which is the best way to isolate the water on the C/H and cold water supply...

Thanks, so I can isolate the cold water from the mains, but to drain any existing water in the boiler do I undo the white drain plug on the L/H by the heat exchanger, as for the C/H if I turn all the rads off upstairs the only water left in the system will be from the pipe runs and what’s left...

Thanks for your very helpful advice, I was only asking for some simple friendly advice.

Hi all,I’m hoping someone can help me out, I’m about to replace the diaphragm on the diverter valve and replace the heat exchanger, but a lot of people say don’t touch the isolation valve on the C/H flow and return as they are prone to leak after, need some advice on what to turn off to do this...

Hi, yes I know this is a very old post but I’m hoping someone can help me out, I’m about to do the same thing, but a lot of people say don’t touch the isolation valve on the C/H flow and return as they are prone to leak after, need some advice on what to turn off to do this job, should I turn...

Should I just leave the LCD timer connected or disconnect it

Thanks stem, I have searched but unfortunately can not find anyone that has wired up to my specific model.

looking to instal a nest thermostat to my Worcester 28cdi boiler, I have no other thermostats connected just have a digital timer. Do anyone have any photos or wiring diagram to help me out. Thanks