@stem thanks for your quick response. Please see the photos below to hopefully confirm where the wires are connected too and the model of the Danfoss Thermostat (TP5000).
I think ideally I would rather have the receiver near the boiler and out of site rather than on the wall as it isn't...
Thanks @stem for your detailed reply.
Yes unfortunately there aren’t any diagrams detailing what each wire does, for a new build I didn’t expect much.
Apologises, yes it is a combo boiler so I don’t require hot water control.
Going by what you’ve said, the receiver will replace the...
Hi,
I apologise if this question has already been asked.
I have recently purchased a Hive Active Heating to upgrade my Danfoss thermostat (x2, one for upstairs and one for downstairs) (battery powered and has two wires connecting to it).
How do I connect up the two receivers based on the...