Recent content by unclebob1

Morning All, FIL's place, the original fitter sadly passed away, so not available to ask, and FIL is clueless on the setup. Black tundish is dripping/spurring water out at intervals, enough for it to be splashing out in the viewing area of the tundish so using the insulation to guide it into...

Which bit did you undo? You can remove the insinkerator by twisting (with the supplied alan key) on the lower metal ring (above the plastic body). If you have done it that way, make sure both lugs match up with the gaps, then twist anti clockwise to lock in place..

Yep- I was relaying the info that was provided to me - incorrectly - so Apologies! I'll double check if its set as entry, and will also replace the contact. Its disabled as a zone at the moment.

The back door is set to double chime when opened/closed which works as expected (i.e. chimes when opened). Occasionally it also chimes when the door has NOT been opened. This is causing the alarm to activate when set (as if someone has broken in). and apologies this is different behaviour to...

Just to update, both the external and internal sounder + keypad sound. Internal sounder hasnt got tamper set. Played around with the chime setting and set a couple of them to double chime etc to try and pin down if it was a zone, a door contact seems to be the culprit, but as above, nothing in...

I'll double check the tamper side to make sure its connected - would it not still show as a tamper on the panel as bell though?

Hi All, I had a long installed I-on 160ex installed prob nearly 10 years ago, but wanting remote control from mobiles required me to migrate to a i-on G3MM. There are two wired expanders + the main panel + 2 keypads all wired. Swap from 160 to G3mm was just a swap of the main panel, expanders...

That's how I read it but wanted to check - looks like time to get notepad and pen out to write down all the zone details!

So it wont reset the names, type etc of each zone when I change to partition?

Yep I have the engineer code

Morning All, I have a Scantronic 9752 currently setup with part set (A, B, C D) for different areas of the house to arm (eg windows, doors, down stairs, upstairs). Use of the house has now changed a little, and want to change it to partitioned system - downstairs and upstairs. There are also a...

That's exactly what seemed to have happened. I've reversed it and all is working ok now. Thanks for your assistance!

It still showed as the initial image. I went into rkp and removed Zone2 from rkp1, and the zone4 went back to normal.

Looking at rpk's I suspect somehow zone four has attached to rkp1 Zone2

I removed the tamper loop altogether and just put a piece of wire on the panel, same error.