Recent content by vanr

  1. V

    Hive Wiring to Replace Watts BT-WR02-HC RF Receiver for Underfloor heating

    Thanks Stem for your reply. I have now had it sorted. Indeed the culprit was the Watts RF Receiver. Connecting Polypipe Single Zone Master Unit (PB1ZM) (T2 --> Hive 4: Heating on) fixed the problem. I then had one additional problem in that when using Hive to switch the heating on it also...
  2. V

    Hive Wiring to Replace Watts BT-WR02-HC RF Receiver for Underfloor heating

    Replaced the Polypipe Single Zone Master Unit (PB1ZM) today and connected (T1 --> Hive 4: Heating on), but no joy, seems T1 has a low voltage on it. So going to call an engineer to sort out will post once I have the solution.
  3. V

    Hive Wiring to Replace Watts BT-WR02-HC RF Receiver for Underfloor heating

    Thank you for taking the time to respond. I have now wired in the Hive (T1 --> Hive 4: Heating on), but when pressing for heat on the hive receiver to test it, the boiler is not coming on, nothing happens not event the clicking noise as described below. Have put the wiring it back as it was...
  4. V

    Hive Wiring to Replace Watts BT-WR02-HC RF Receiver for Underfloor heating

    I currently have a Polypipe Single Zone Master Unit (PB1ZM) connected to Watts Receiver and Thermostat to control my underfloor heating. The RF Receiver is playing up so going to replace this with a HIVE Active Heating dual channel setup, which will also allow me to replace the Honeywell...
See more
Back
Top