Recent content by Vaybear

OK, I'll have to look into this then. Cheers :)

It does mean a lot to me, but the hole where the wires can come out of frame is where the wires are (take a look at the first pic). I tried installing it the right way round but I couldn't push it in properly because the hole on the wall wouldn't allow it. Hence I have had to install it sideways.

Here is the pic of my wiring, I'm a bit concerned about the blue wire. Although, it doesn't look that much different from how my old one was installed (by someone else before we moved here): At the moment it's only connected by one screw to the wall. It doesn't sit flush and I'm waiting to...

Thanks again. After great difficulty I have now installed the new fan! I was wondering, if my botch job allows condensation to enter the internals and the fan explodes or something, will it cause an electrical fire or damage the various wires permanently?

Thank you for that. I have one more basic question, in the new image the input has two screws below each wire. I just need to connect my existing wires to the first input right? And it will link up to the second part? Example: I raise the first screw on N, put in my black and blue wire, secure...

Hi everyone, I'm trying to install a new extractor fan. Problem is that the new fan has 3 inputs, whilst my old one was installed with SIX wires. What I'm trying to install: What I see when pulling off the cover of my old one: I have lifted the flap of my old one but there is no indication...