Recent content by vomboy353

Had a reply. He has asked me to check for loose connections within the unit. If it's still the same, I'm sending it back and he is going to replace it with a new one. Thanks for the replies

Yeh, got the Fluke T5-1000, it auto selects dc-ac

0v, assuming my meter probes are getting a good connection on the pins of the plug. Am I right in saying the PSU should give an output of 9-16V?

I have just purchased and installed a Pyronix Enforcer V10. It does not power up on the Mains. I have 230v at the incoming. I think faulty PSU? 20 years as an Electrician.

Thanks Tony, Will it be better to put a concrete lintel in, as they are cheaper. I'm still unsure about how strong the long part of the wall may be. I have been looking at putting in a wall starter and brick pier on the inside of the garage once I have cut the doorway out, just to give the...

Hi masona, Thanks for the reply, The garage is a free standing garage. The door will allow me to get from my garden into the garage. The joists sit on top of the wall with bricks between them. I have taken a picture from the outside of the garage, the door will be going where the...

Hi I am looking for some advice to help me decide whether to take on my new project or get a local builder to do the job. I am looking to fit an exterior door in the side of my single brick flat roofed garage. What is the best type of lintel? I was condsidering this type...

i have a spare way in my consumer unit but it is on the left of the rccb the rccb has a spare point for the neutral, so can i move the rccb one to the left then put my 16amp mcb in. and the live of my cable in the mcb and the neutral of my cable into the spare point of the rccb? would this...

I am currently installing an airbath in my bathroom The kit contains a heater at 13 amps and a blower unit at 5 amps. I wanted to run a 2.5mm twin and earth from my consumer unit to my bathroom, to 2 fused spurs one with a 13 amp fuse and one with a 5 amp fuse for further protection to the...