Recent content by wannabebuilder

back to the drawing board :( I'll probably change it to have some overhang and install some vents. Re:fall - i'll see what i can do i might have a few degrees if not then i'll probably make a new lower base which is going to be easier than rebuilding all the sides. It's all a learning curve :)

ok too late for thermaroof. could you just confirm that this would work ok and if i do it like this i won't have any condensation problems. 1.roof deck 2. 50mm sheeps wool insulation or Rock Mineral Wool (between joists) 3. 100mm kingspan rigid board (between joists) 4. plaster board...

thanks again freddymercurystwin let’s say i go with 50x150 + 18mm deck (i should be ok height wise) and then I use 100mm kingspan which leaves me with 50mm space between insulation and deck. How do I vent that area if there is no overhang so no soffit vents? Is there another technique...

if your friends pc is "branded" suchs as HP, dell etc and you try to use your own copy which is "retail" then his key won't work with your copy. You could always install your copy and then call Microsoft and register over the phone. Just give your friends serial number and they will give you...

Thanks for your reply freddymercurystwin the span is 2.5m. re:the height limit I said building regs but I meant planning rules :) 2.5m max height if right next to property boundary re: condensation is there a potential condensation problem if everything is filled in with kingspan (no...

looks good. just wondering where you found 18mm osb3 boards for £6?

Hi all I am building a garden room and don't really know much about flat roofs etc (IT guy). I have built all the sides and floor/base and the total height so far is 2308mm. That leaves me with 192mm to construct the roof to comply with building regs. Now it's too late to build a warm...