Welshgasman's latest activity
-
Welshgasman replied to the thread Replace analog timer?.I am planning on using that Siemens RWB29si programmer. I already have that fitted to a backplate and another plate to be able to bolt... -
Welshgasman replied to the thread Replace analog timer?.I think I have already stated that gas is still cheaper for me for HW only. I am happy to keep it as it has always been, HW only or...
-
-
Welshgasman replied to the thread Replace analog timer?.Ok, I think, now looking at this picture, I am in a pretty good place? All I need to do is wire the new programmer exactly like this...
-
-
Welshgasman replied to the thread Replace analog timer?.I know the feeling. :( My memory is shot these days. Yes, I have 4 wires. 1 is the power from a 3 pin mains socket. 2 is power to the...
-
Welshgasman replied to the thread Replace analog timer?.Well I have been upfront with a few electricians about what I have and what I want, and none want to touch it. :unsure: I have looked a...
-
Welshgasman replied to the thread Replace analog timer?.I went looking to see how that sideplate comes off. Not sure about those on the right? Google AI has advised me that the programmer is...
-
Welshgasman replied to the thread Replace analog timer?.Here is the end of the programmer where all the wires are fixed into it. From the little I know, L2 and L3 when connected give me HW...
-
-
Welshgasman replied to the thread Replace analog timer?.OK, I decided to ask ChatGPT, and it was very helpful. However I would like a human to confirm if it is correct as it has been wrong...
-
Welshgasman replied to the thread Replace analog timer?.I think L2 - L3 is HW only? L1 - L3 is CH & HW. I do need DHW on it's own for summer. The programmer failed again today, did not move...
-
-
Welshgasman replied to the thread Replace analog timer?.Going on the assumption that I am on the C plan, would you be able to give me the wiring instructions please? I believe L2 would also...
-
Welshgasman replied to the thread Replace analog timer?.Me too. That is why I have used the gas for years. I will monitor my immersion heater for, let's say 1 hour per day. That should be...
-
Welshgasman replied to the thread Replace analog timer?.No, the gas meter is just units. I have to apply the factor to get the KWh. I would expect even I have a thermostat buried in the...
-
Welshgasman replied to the thread Replace analog timer?.My Electricity is 25p per KWh. My Gas is 7p per unit. I just switched on my immersion heater and it appears to use 2.9KW, so is going...
-
Welshgasman replied to the thread Replace analog timer?.Thank you for the calculations. I have no off peak supply. I will give it a go as well. I have an Owl monitor that I have used for...
-
Welshgasman replied to the thread Replace analog timer?.I am in Swansea. My immersion heater is directly plugged into the wall, unlike the boiler. So I could change it to a normal 3 pin...
