Recent content by welshviking

Many thanks for all your help, i will show the electrician in work what you have suggested, and will let you know the outcome......thanks again Colin

I will try to take a couple of decent photos in a minute, the details on the case are INVENSYS 4R 5594CC 48/07 41026074-GA11E09 ANOTHER NUMBER ON THE CASE IS 31001953

I was cheating as my wife was doing the typing while i was looking at the washer, anyway removed the pcb just to see if i could see anything obvious...and look what i found (looks like TC3 has blown and destroyed most of the tracking around it also the tracking at the top of the board J12 J13...

Yes it does make sense but unfortnately i have no longer got a multimeter also it looks like it is well beyond my capabilties, i will have a word with one of the electricians in work to see if he will come to test it and take a look at the pcb while he is here...Thanks for the help anyway it was...

Ok looking at the heater elemant, removed the 3 wires (2 reds & earth) and looks like it is held in by 3 nuts, do you just remove them and it slides out. I will check the pcb after i have looked at the elemant...Cheers again for you help. Sorry ignore this, found out that the elemant is only...

Ok i think i know where the heater elemant is (behind rear cover at the bottom) but not sure where the pcb is ? Cheers

Hi Thanks for the reply, the rcd tripped i am almost certain it was caused by the washing machine as it seems to much of a coincidance. The old door switch actually looked fine as far as i could see but i replaced it as i thought it was the switch at fault. Too be honest i have not checked the...

I have a candy go1282 washing machine that has stopped mid cycle and i found the electrics in the house had tripped ( not sure if it was the washer or something else that tripped the electrics), now it will not do anything as the door lock indicator is flashing constantly even when the door is...