Recent content by Wheato95

All I needed was to move the black cable and I was done! Haha least it’s done No honestly buddy least I can do is get you a drink!?

I’m 99% sure it’s working. Grinch you are a legend, could you ping over your PayPal email

Right goes to stat Centre goes to cylinder stat Left goes to grundfos pump

Hot water is working mate, sorry for delay had to re-pair hive

Yes I did buddy. Didn’t change anything in the backplate. I’ve just reconnect BDR and put Drayton back on its working fine. Do I need to bridge out the stat? My mum just wants a fancy wireless stat!

I believe dual channel? The wireless stat used to control the heating and they always had hot water..

Thanks for the reply Yes the back plate is from the LP241, no wiring has been changed there. See the pic for before the BDR was taken out. Bare in mind terminal 1 and 11 have a cable less as I was tidying up the wiring but they are back in position

Morning all Installed a Hive at my dads, the issue I’m having is HW is permanently on. I can turn HW off via app but it switches back on. I have removed the BDR and the grey from terminal 2 is looped to the live going to the stat.. I believe this is where my issue is? Another slight issue is...