Best of luck. I always check out the sensors before wiring to the control box. A meter with an electronic buzzer or a ohm meter will tell you if the contacts are working correctly eg when either door is opened indication at the control panel end says Open. If you don't have a meter try to...
Each sensor should be connected to it's own zone. Assuming you have 2 zones available then you need a pair of wires for each door.
If you only have one zone then the door contacts will need to be in series. The contacts are closed when the doors are shut and either door will trigger an...
Thanks to you guys who read the root posting. Without any expert answers I have carried out experiments and I believe the connections are as follows:
SW4 ON
SW1 to 3 OFF
TEST, SET and RLED not connected
These settings allow the LEDs to function and the TEOL gives 2.2 as normal, 6.9 for...
I have a Prestige 24 panel and need to add ADQD sensors. The installation instructions don't explain the settings very well. The switches are set ON by default - what are the usual settings. I am guessing SW4 ON, SW3 ON, SW2 ? SW1 OFF
The terminals I think are Test NC, SET to 0v and RLED NC...