Recent content by wildyoungdirgy

Sounds like the fan was fine, just installed with the wrong type ducting. It was a complete kit ...fan ducting bezels and light. Will look at the fans you suggest... Dave

Either you have a problem with moisture sitting in the fan, which is an installation fault rather than being due to the fan itself. Well, I situated the fan with the connection box uppermost, and at the highest point in the ducting run. ie the duct came from the ceiling up to the fan, and...

There should be NO mains voltage anywhere near this type of fan, where did you mount the transformer ? the remote safety isolating transformer. Well there is Mains directly on this one. The label on the connection compartment says:- Manrose Manufacturing Ltd. Fan Type DF100BLK 220-240V ~...

I wouldn't have thought that the moisture from the ducting should have been able to make it into the terminal compartment under normal circumstances. Wrong..... There is a 6mm hole between the connection compartment and the air duct where the 2 thin wires pass to the motor. Even though the...

Hi, Anyone else had this experience over the extreme Arctic conditions? Bought a B+Q (Manrose/Marley) basic Showerlite (illuminated extractor kit) and fitted it above my shower with the fan in the loft above, venting to outside. Been fine for the couple of weeks before the cold spell, then...

How can one monitor the output of a house light switch (apart from looking at the lightbulb)? I need to electrically monitor whether lights have been switched on. I also need to switch them on remotely. The remote bit is easy ...pair of isolated relay contacts across the house lightswitch...