Recent content by wmshome

Does anyone know of any decorating/Painting ways to cover horrible artexed walls...

Would need to bring someone in. If i did it, it would look worse than the Artex. Have heard there is paints and things you can use to cover it...

I have horrible artexed walls, and want rid of them. Any ideas? Can they be covered?

Thankyou 'gasguru'. Answers my question fully, and thanks for the tip with the valve. Can see what u mean...

Yea yea ok... I can plumb all day long, but have great problems with communication, lol... My sincere apologies. But hope you get what I mean now...

Use normal screw in clips, and just pop a little block of wood behind it. Takes 5 mins to cut the wood, and is cheap as chips...

Being fully qualified in the unvented systems myslef, I do not have a problem with the installation of the cylinder side of things. The question I am asking is about the Electric boiler. It is my first time of installing one, and feel it may need one as a saftey device, as it is a sealed system...

I have an Aztec electric boiler, and a Ariston sti125 indirect unvented cylinder... The problem I have is with installing the expansion vessel/s... From the Ariston Cylinder installation guide, the expansion vessel goes after the combi valve on the cold coming in. This is fine I think. But...

washing up liquid does make it a bit slipery... I allways put them on the toilet first, and then in the hole. This enables you to turn them as you push, and I find they just pop on. Also if it is a flexi, it could be pulling too much..... Hope this helps...

Is this a noise that comes on when you flush the toilet or have run a tap? Try replacing your ball valves...