Recent content by Woggle

Yes that's right. Looks like it's that way.

Yes that's right - I can move the entry / exit. The Konnected device has six zones (+/-) and then 12+/-, alarm +/- and Aux-. The issue I've got is that the zones on the previous alarm grouped multiple PIRs. For each zone (plus entry/exit) it looks like I've got a black and red wire (power)...

Hi there, I need some help finishing wiring. I’ve got 5 PIRs - Entrance Hall (which is entrance and exit - when I walk into the house and the house is alarmed it doesn’t go off), Lounge, Kitchen, Utility Room and Study. I would like to ideally see them all individually in SmartThings. I have...

Hi, I've layered in some hardibacker board behind a log burner (I've checked the necessary distance from the stove). I would like to tidy up the line - between the boards. Ordinarily I'd use decorators caulk but obviously this needs to be fire retardent. What would you suggest? The other half...

Yes

It's already brick/masonry at the back - but the cavity between it and the outside wall isn't filled - which is why we're losing heat compared to the rest of the room.

No - it's in the cold (when the fire isn't on) that we're losing almost 4-5C through the back of the fireplace. We don't have the fire on permanently - it means the lounge gets cold (which is the largest room in the house). So hoping this will make a bit of a difference.

Just resurrecting this thread.....any ideas please?

What's the best way to insulate the recess of a fireplace (when I say best I mean both cost effective and safe!). As you will see from the photos I'm using quite a lot of heat out of the back of the recess (when they did cavity wall insulation this bit wasn't insulated). I've had the following...

Hi there We've got a shower which has been playing up and I now can't move the right hand dial enough to get the shower warmer. It has become much harder to turn - so you can't turn it further than a lukewarm temperature. Any ideas what might be causing this? We do also have an issue where...

We have got a shower which is connected to a shower pump in our airing cupboard (Salamander Pump 96-021 38). The shower has a rainforest head and then a normal head. Turning the left hand mixing dial turns the shower on/off and allows switching between the rainforest head and the normal head...

DONE IT!! A lot of twisting and pulling....... O-ring is broken which will explain the problem. Thanks ever so much!

Lifts and comes up a bit but doesn't lift out (either by lifting or lifting and turning).

Will give it another try. It hasn't come out that easily so far....

Thanks for the response - I'll take a look at getting the cap. I can't see the isolation taps for the water. Other issue is that there's no screw for the riser so I can't get it out (or can't appear to work out how to get it out to replace the o-ring).