Recent content by wookey

Cheers. Yeah that DC-1 connector might do the trick if I stick with the existing 1960s loo (which is in reasonable nick). But I'd have to be able to drill/chip/break off the concreted-in cup on the tail spigot without breaking said tail and I'm not sure what my chances of that are. Also it's not...

OK. So lets say I'm not all that smart and cracked the collar off the old pipe, so the lowest point is about 30mm below floor concrete level and will be about 130mm below finished floor level (it's getting insulation added). I guess I need some sort of extension fitting to bring the pipe up high...

Fitting UFH isn't particularly difficult. I did mine. For pressure testing just connect the mains up and have a gauge on the manifold to see that it stays pressurised for a few hours or days. Leave it pressurised whilst the screed is being done. if it's going to be a while (months) before it...

I have an AS2000 shower and need to know the spec of the O-rings. After taking it to bits and reassembling it leaked at all 4 connection-elbow to central valve junctions. The original O-rings were quite hard and oval in both plan and cross-section. I assumed from long use (it's at least 15...