Recent content by xpeterpx

Thanks. Is there a standard size grub screw used on these?

Just curious, should there be some sort if screw/ grub screw in this small hole in my upvc handle? Doesnt seem to affect operation despite it being missing. Thanks

Thanks as always guys

Ideally a task I would do myself. I need to wire in a new cooker hood into a fused spur in the nearby cupboard. The hood is attached to a moulded plug. After isolating yhe circuit Can I just cut the moulded plug off strip back the wires and connect it? The current hood is wired in like in this...

Thank you

5 rads, 2 x half rads and EV in the boiler

Thanks, thats what concerns me. How can I control that pressure. To be honest I would prefer it at 2 bar to be on the safe side.

1.2 bar approx

Just thought to run this by you lot, these are my current boiler settings. If you note the bar seems to run at 2.5 with water at 60 and heating at 18 deg. Whereas 3 is a problem if it reaches there. So are my settings correct and should I be concerned? Boiler has always run at 2 bar but seems...

Thanks..Not sure I follow

Is there any specific reason I shouldnt use bathroom paint in my poorly ventilated kitchen? Thanks

Thank you. Any ideas why there would be the 22mm speed fit connector on that pipe?

Was just about to fit a new thermostatic bar with those tap pillars. Thought it might be a quick swap even though its a bit of a difficult access job until I came across this set up. Looks like a standard 15mm hot water flex but if you look beyond that to the hot water pipe I cant understand...

My cold water pipe is near a wall at the far end of the bath and there is minimal room to get to it. I need to replace the bath tap at that end but it's going to be a real challenge. Any recommendations for a far reach too that will be up to the job? Thanks

Hi guys, just thought I would run this by you. I have the Ideal Logic C33 combi and although no apparent issues runs at around 2.5 bar when its been on for a while. It sits at 1.2 bar when cold/ not in use but just wondering if it at 2.5 runs too hot when in use? By the way we normally run it...