Recent content by Yappuno

No, the bracket at the bottom of the towel rail (that you can’t see here) is perfectly aligned with the wall and the towel rail. It’s only the top brackets that you see here which have this bad fit. I am pretty sure they were installed like that, because they need to compensate the gap between...

I reckon the vertical distance is 5mm maybe? See photo. In any case I suspect too much for the built-in ‘give’ on the standard bracket, as that’s what is in place now, but they had to substitute the hard top that came with the bracket for a softer flexible one that turned out to be unsuitable...

Hello - are there wall brackets for heated towel rails that allow for the heated pipe to be slightly lower than where the hole has been drilled into the wall? I have seen brackets that swivel left and right to accommodate curved towel rails but nothing that swivels up and down slightly...