Recent content by Zeddd

I will be hopefully be replacing the lead from the street ( ST water to do the connection on road side) to my home in mdpe. But old lead goes under my garage and into my kitchen. I want to instead take the incoming supply into my garage and attach to the copper cold pipe there instead (with...

Actually the lead starts before my diagram here. It chnages from lead to copper then to my stop tap which is directly beneath that first circle shown. So if I cut it off just below the but feeding the first circle. The dead leg section will be very small. Maybe 1-2cm. The new incoming pip...

I see! I guess it’s to make sure the water at the dead leg is flowing about? What if it’s cut closer to that 1st tap? As per this attached image?

Hello I currently have a lead pipe for my cold drinking water. I wish I changed it when I renovated my house but I just wasn’t thinking. Kitchen is all done up now, and the pipe currently enters directly below sink. It would be difficult to change the pipe from there now. The boiler is in the...

It wasn’t me who actually reset them. It was the wife! So I couldn’t say right now. From the conversation a few were tripped (upstairs lighting, upstairs sockets and downstairs conservatory as a minimum) and she lifted them all except the conservatory one which is the one that’s refusing to go up.

No the conservatory lights are on a separate circuit. The faulty circuit literally includes: 3 x Double indoor socket 1 x Outdoor socket which is spurred from one of the above 1 x Underfloorheating protected with a FCU

So I removed the outdoor socket (which was wet a little on the outside but dry inside as it is a sealed unit). I removed the cables from the socket and left them exposed. Then tried to reset the MCB. But it still would not go up and still took out the RCD. Can I be confident that the...

Oh I see. It already has a unswitched FCU. So wouldn’t taking the fuse out of that act the same as a SFCU?

The underfloor heating is unswiched. It’s one of those that you need to pop the fuse out using a screwdriver if that makes sense. If it is the outdoor socket. I can try isolate it from the rest of the circuit easily as this is spurred off. So I can disconnect the spur wires from the socket...

The underfloor heating has a fused spur. It’s this fuse I removed.

The thing is nothing is plugged in. We don’t use interior sockets at all. The exterior one has nothing plugged in either. The underfloor I removed the fuse from it so this should have turned it off?

The irons gone in the bin as I know that was faulty. But is it possible that the fact that the iron tripped the entire house that it’s somehow damaged the MCB for the conservatory in the process? Or is that wishful thinking. My next point of call is the outdoor socket - as this is quite close...

Hi All Has a strange issue. Was ironing upstairs and all the electrics were tripped. I reset the RCD and switched everything back on and upstairs is working all fine. Strangely though, the downstairs conservatory sockets are no longer working. The MCB that controls the conservatory...

Sorry should have been more clear. Have updated the picture. It is the stuff on the bricks... The one circled on the right seems to look like its dissolving away!

Hi All Any ideas what is happening in here and anything serious I need you worry about? Thanks!