Search results

  1. C

    Flomasta fil valve

    Thanks it's not shutting off fully. But can seem to get to the washer on it
  2. C

    Flomasta fil valve

    Is this fill valve serviceable?
  3. C

    Swapping waste and siliconing bath same visit

    I need to swap the waste on a bath and silicone the bath to the tiles. If I swap the waste first (I usually use silicone on the bath waste were the base of it touches the bath). Will it effect the waste seal if I then fill the bath with water before I silicone the bath to the tiles?
  4. C

    Concealed shower head

    I repaired a 3 way concealed shower new cartridge and on off cartridge to the main shower head. Worked ok for awhile. Now it is making a rattling sound from the main shower head. A flow is slightly reduced. I wondered if maybe there was a build up in the shower head after using it after it not...
  5. C

    Pan connector

    Arrow to point
  6. C

    Pan connector

    Is it normal for the inner ring to have a split in it? Thanks
  7. C

    Sulphuric acid

    Boiling water?
  8. C

    Stiff shower cartridge.

    Thanks it's a Hudson reed one. Apparently they no longer make the cartridge for it. Was a strange design. It turns the water off and also diverts from the shower head to the shower riser.
  9. C

    Flexis tap connectors for baths

    What a people's thoughts on this? Flexis can rust and corroded and then blown under a bath you'd never see the condition of the flexis...
  10. C

    Stiff shower cartridge.

    Is it possible to take an on/off cartridge out of a bar shower to grease with silicone grease as it's stiff to turn. Thanks
  11. C

    Concealed shower

    Thanks so if I take of the control knob off for the one that moves the temperature up and down. There maybe a way to adjust it so can move/turn it hotter?
  12. C

    Concealed shower

    Is there usually a way of adjusting the temperature stop on these to make it abit hotter. Thanks
  13. C

    Vanity basin draw

    So pull forward filling and maybe trying lifting upwards when fully out?
  14. C

    Vanity basin draw

    Any advice on how this draw removes please?
  15. C

    Plumbing lecturer

    Anyone worked as one? Started a position a few months ago. The boredom is unreal though. Anyone been through the same
  16. C

    Swapping part 1 for part 2 float valve

    Does that sound about correct?
  17. C

    Swapping part 1 for part 2 float valve

    The over height is 140mm from the bottom of the tank. So is quiet low. It's usually recommended the cold hight of the cistern is 75mm below the overflow flow height?
  18. C

    Swapping part 1 for part 2 float valve

    Thanks if done similar and swapped part 1s for part 1s. Just thought a part 2 would be better and hopefully use the same technique
  19. C

    Swapping part 1 for part 2 float valve

    Is it possible to swap this part 1 float valve for a part 2? By splitting the valve, leaving the tail in the tank. Thanks
  20. C

    Filling loop

    What's this screw for on a filling loop?
Back
Top