Search results

So was likely it came out of the factory like that? Did they check to see if had been tested to 18bar. Apparently they can tell by how far the grab ring has bit in to the pipe.

It wasn't tested to 18 bar I know poly say to do this I do on new builds but on domestic central heating install It hasnt been.

Never had a polyone go on me before so will see...

Thanks I'm hoping for a nail. Have had that before where the nail has held pressure then rusted and started to leak.

Just standard grey poly and tube.

I haven't taken the floor up yet. It started with a damp patch on the ceiling over a couple of weeks and now it has started dripping though the ceiling.

Has started progressively.

Hi does anyone know why a polypipe fitting may fail on a central heating system 1.5/2 years since install?

I have a tap to change on this so will have a new pop up waste bar. Is it possible just to just replace the washer and and little metal threaded connected that connects to the waste and the bar. Instead of replacing the hole waste?

Is swapping the cartridges in these similar to a normal tap cartridge?

Well it did seem to nip up 1/8 of a turn or so and isn't leaking now. Worth leaving alone? Is bottom of the system so a full drain down to paste etc.

Thanks must be a slow very small leak. Would paste be an option too?

What would be the best way of fixing this leak it doesn't drip just builds up like that after a day of the water being on. Thanks. Guessing it's on where the olive meets the pipe and the nut as opposed to the olive and valve body.

Thanks it didn't seem as thick as the heat resistant stuff they sell now or the stuff I have seen. Thanks again!

Is this 0.75mm flex heat resistant? I don't think it is. Thanks

Should it bite up to the pipe on it ok.

Is it possible to swap the p trap on a double bowl connector for a anti vac one?

Can these go into the top of a waterless traps inline adapter or are the rubber push fit 32mm to 22mm reducers better.

Looked online some blubber taps you can adjust the flow on the tap. not sure if you can on the one I fit was no instructions. the ones online it says you remove the top and adjust a screw on top of the cartridge. If you could on this tap would of thought they would provide instructions or is it...

The service valve turned down abit do a similar job?