Search results

Most people will just fit them without a prv. ?

I was looking at some taps. It says in the document with it max pressure 3 bar. Do most taps suggest this? As most people will have more unless a pressure reducer is fit or there in a unvented hot water heater with the feeds balanced down to 3 bar after the composite valve on the feed to the...

I think I read it's ok as long as you use the correct liner for that brands pipe

Is it ok to use he2o fittings on speedfit pipe?

So I have the new valve I am going to swap it. Can I ask the gauge that screws in to show the pressure has an o-ring in the end. Bit if screw in tight it doesn't have the gauge showing vertical. (As the picture). Would I be better using loctite 55 cord so I can get the gauge vertical so is...

Will there be a spring under the plastic cap?

It won't effect the pressure reducing mechanism inside?

They screw out easy enough?

Implying taking the head of and PTFE ing the o-ring?

I have this pressure reducing valve leaking from where the black plastic bit screws in to the brass housing. Is a new prv the best fix here? Thanks

No fibre washer to perish

Thanks I didn't no could do with a nut and olive though. It is an acceptable/ good way of doing it?

The tail on taps have a bevel now that will take the seal of an olive. Does anyone pipe taps up with copper pipe and a nut and olive. Instead of a no.62 tap connector or Flexi?

Thanks it's all mains pressure

Best not to?

Is it ok to pipes these up with flexis with an iso valve?

Would it be advisable to try putting Rockwell around it to try give abit of room?

It's an elbow for a rad.

If I had to could I put rockwell around the fitting?

If putting plastic pipe in a wall chase. Is it not advisable to solid plaster over any fittings?