Search results

Thanks all sealed systems are closed loop?

What's the best way of avoiding cracking a toilet pan when screwing down to a concrete floor. With regards to possible over tightening to stop rocking.

Thanks yes problem Is the overflow is above the cold feed connection

Would this old tank valve swap for a part 2 float valve? I'd have to take the whole valve out and connect back on to the tap connector. I know who ever fit it has put the overflow too high.

Does the zone valve on the boilers flow to the underfloor heating manifold usually go near the boiler/heat source. Or near the ufh manifold? Thanks

How does the hight adjust on this is a metal bar not the usual plastic one

Thats the hole in the pan/cistern

Cause it telescopic you can split the valve and replace the top part

Just replace the top part?

Thanks the arm of the full valve seems abit different metal extending to the float.

Thanks think would have to be a box spanner but not sure if room to get it on

Do you twist and pull the top cap to remove it?

Its the type were the inlet hole also goes through the toilet pan hole

Thanks yes it overflowing

Hi do they sell washers for this fill valve? I believe it's a fluidmaster.

To change the fill valve on an ideal standard toilet do you need to remove the cistern? The pan kind of has a hole around it were the fill valve goes through.

Has anyone done any underfloor heating on the first floor of a property? Have only seen it on the ground floor before.

Is it ok for hot /cold water to flow in to the branch of a tee. And then split both ways to feed a property?

How much kilowatts of heat will 15mm/22mm/28mm copper pipe usually transmit ok? I imagine it can differ with different flow temperatures. Just wondered were I could find ball park figures? Thanks

Is there anything wrong with using a crimped fittings under floorboards downstairs in a property on central heating?