Search results

Yep I had this also you need to select normal then for full arm/part arm select what you want e.g instant alarm then when you see that menu again i.e full arm, part-arm scroll down using down arrow key and you will see next then hit ok - should continue from there by adding name and voice tag...

Hi guys Fitted this myself the other day with 2 x PIR and 2 x Door contacts - all working well. Then powered down system and fitted a Vodafone payg SIM card . I can dial in and both Arm and Disarm the system. But it will not allow me to remote command via SMS nothing happens even after setting...

Thanks for the info, can i make the neutral at stat side"safe" and leave the other side connected, simply as i do not want to open up the junction box its all wired up too. Thanks

Have a ariston boiler system boiler. Drayton RTS1 room stat and a drayton Lifestyle LP112 programmer. I want to replace the RTS1 with the honeywell DT90E - I believe the system uses a neutral to switch @240 mains also in conjunction with this lifestyle timer. So do I need all 3 wires to...

Hi I am about to do the exact same thing...what were the steps with regards to the Neutral connection from the timer, or can we just ignore it and make it safe? Thanks Akbar

Hi I have a Ariston microGenus 27 system boiler (condensing) Separate Room stat (simple drayton analogue) Seperate timer. This is a new issue I have not seen before 1. CH and HW set for morning, room temp on stat set at 23c 2. Boiler runs fine for 30mins 3. CH pump overrrun keeps...

Thanks Tony, so do you provide services within the Berks area if so do you have contact information so I could discuss a possible quote? Thanks Akbar

Done some further testing last night. So the issue is only there when I demand hot water at full speed, if I open the shower or basin tap mixer to full the flame light LED notification shows its running at full and it do this "30-40 sec cycle with pump overrun" However if I run the...

well the water is fairly hard where I live so I can expect scale build up. Is this an easy job then? Thanks Akbar

Was installed by CORGI installer from local area who is very reputable. I intend to call him back anyhow but would like to know the area at possible fault at least. As I spoke to some other heating experts they all mentioned this secondary heater exchanger likely to be blocked, what is the...

As above Ariston Genus HE 24 - CH works all fine. DHW - set to 50 degrees. Run shower at full pace - will run fine for first few mins then... the DHW pump overrun kicks in every min or so resulting in a few seconds of a colder shower (like a constant cycle of boiler firing on and off)...

thanks, yes ive heard of those. I look into that straight away.

Do i require a soil pipe vent of some sort if installing a WC in the garage to a main soill junction to the house (2 inlets, 1 oulet) the garage is circa 15 m away. the drop would be about 1:40 ratio. TIA

just purchased this from http://www.screwfix.com/prods/89417/Bathrooms/Showers/Mixer-Showers/Manual-Showers/Triton-Dover-Manual-Mixer-Shower and all pipework has been done behind tiling. Just realised the hot and cold water feed are the wrong way around, now I realise this poses a safety...

Warm Hello to everyone, I am a newbie just looking for some general advice. I have had an annex built at the rear of my house with a WC, Shower and sink waste connections all connected in the following configuration. (please excuse use of terms and correct as necessary) 1. Main brown soil...