Search results

Yes probaly won't need much sand though if you have enough plaster

To me it sounds like it's possibly an intermitent short between live or neutral to earth or connection breaking down. In my experience testing with a megger or such at a higher voltage will show thiis type of fault quickly. So as long a the next guy tests properly it should show up without too...

Page 8 https://www.agaliving.com/sites/default/files/user_guides_uploaded/06-22%20EINS%20517973%20RAYBURN%20HEATRANGER%2060K%2080K%20100K%20GB_0.pdf The limit swwitches seem to be avilable with a google search but you would need to know the correct part number. Perhaps call one of the suppliers...

A good suirt of WD40 and overnight soak first

Probably happened at the bottom due to hot moist air conensing on colder surface at the bottom. Just smear some silicon over the cut edge and allow to dry before re-hanging the door

Your choice but can't see it makes much difference.

Probably set it into the celotex as its easier than channeling the sub floor.

https://www.amazon.co.uk/Steel-Drain-100mm-Plumbing-Blanking/dp/B0BM4WHQ1B?th=1

The suface of the inner or the outer wall, Staright through the cavity not in the cavity as you suggested then any riser that is needed on the inside or the outside which ever is easiest to access once any cupoards are fitted. I would have thought the depth it's set into the floor will be...

Any condensation will evaporate. Especially with underfloor heating. Personnely I would take it on the surface, not in the cavity, above the DPC as you probably won't know at this stage what your outside ground level will be. Use flat ducting.

Has your wife got any acetone naile varnish remover. If so try a litlle in a small area and see if it removes it. That may tell you which type you have or what you need to remove it with.

Agoogle search might help

Got mine from Aldi. It has all the features you mention and works well.

Time for a new armature and check brushes and holders are not fouling

Get a few estimates for the work

Sentence 1 then.

I think you might struggle to find anyone other than Miele to repair your washer. but they do a fixed price repair if you cannot resolve it yourself. If it is going through a spin cycle but not emptying complely it does sound like the waste is obsructed or the pumo motor is failing

Bump the price and profit up. Although perhaps wall warts weren't available when it was designed.

Look for a 12v charge controller for solar panel

More likely to be the duct not installed properly if it goes through a cavity wall.