Search results

Can't see why you should have a problem then. Using a chimney is no different than boxing ducting in.

Before you do any work put a smoke bomb in the alcove and check that the chimney is not blocked and draws air. I presume you have some form of ventilation in the kitchen.

I use the same charger for ni-cad and ni-mh without problem and the charged idicator works ok. I wouldn't try to do lithium batteries with it though. I would suggest you put them on charge early in the morning and monitor the charger is not getting too hot as they charge.

Put it back together and take a pic of the whole thing then do a google image search to try and find the brand

Perhaps a silly question but do you have compresion if you hold your finger over the plug hole while you pull the cord.

You could perhaps split the shroud with a stanly knife and resolder the wires then glue back together with super glue and tape for mechanical strength. Or...

Passed my test in the instructors, but learnt to drive in a 100E

And causing chaos

If you can remove the end cap then a squrt of WD40 might loosen it. Otherwise you might need a new head. Here https://neshome.co.uk/collections/bar-shower-valves or B & Q.

Not sure what colour it is according to manual it says STOP . If the lead runs from the coil to the engine body via the switch and nowhere else then yes that is what I would disconnect. Page 40 onwards.

The survyor will be able to answer your questions. I, nor I think anyone else will be qualified to do that over the internet.

Why are you so obsessed with the cost of energy

Are they going to mole or dig up your drive

Have you tried to start it with the stop switch disconnected. Have you carried out all the other checks in the manual https://cdnassets.stihlusa.com/1654020968-stihl-ms-170-stihl-ms-180-owners-instruction-manual.pdf

It may well be the trres are causing excessive drying of the clay. But my advice would be to get a proper sructural engineers survey and report done. I don't think there is any urgency but he/she woud be best to advise or reassure you. They do need to be repaired once the cause is established.

https://www.plumbingworld.co.uk/plumbing/pipe-covers-clips

Lead flashing? Perhaps photos might help

If the diverter is working ok then is the flow pipe getting hot.

https://www.ebay.co.uk/itm/126115644966?_skw=32mm+waterbutt+overflow+connector&itmmeta=01KHZMDCH8FT9M7KE2Z0R7YRKK&hash=item1d5d140626:g:x9gAAOSwtOVlFT6L&itmprp=enc%3AAQALAAAA4GfYFPkwiKCW4ZNSs2u11xBNdZrCavSvNCv4lO3S5So%2BpMTjYUXvxfYnlvNJvfHUL24%2FDXr8fxBEmtGHUzP1%2BU2L47jMPzk272UUihflNheu1rg2q0g9C...

See section 20 https://www.knowledgebase.egates.co.uk/manuals/wickes-206204-manual/ But the remote you have bought may not be suitable. See section 25 Accesories