Search results

Hello, I have an elite 24 panel and I am looking to add just one wireless sensor to my system. I understand I need the GCD-0001 Expander and one Q20-W PIR. Is there anything else I need to achieve this? I have seen a video about setting up Ricochet and it looks fairly straight forward, is it...

Thanks, I Have set to not sued for now. It looks like the cable was damaged. Sadly it's all been boarded and plastered now so I think I am going to look at adding a wireless PIR and get a Ricohet module. I need to do some more research into how and what's needed though. Thank you!

I think I have found how to remove the not longer required one by setting the zone to not used. So all I need to work out is how to remove the tamper on the remaining zone. Thanks!

Thank you it worked and I am now back in ok. Please can I ask how to remove the sensor from the system? I need to remove zone 5 and clear the tamper on zone 4? Many thanks!

Thanks, I’ll give that a go.

Hello all, We have had some building work done and of the PIR sensors has been cut away and is no longer in use. I had hoped to to try and remove this from the system before hand but that didn't really happen. The Kitchen PIR that was removed is now showing as tamper and I have tried to logon...

Thanks for the reply Danny. Did you have the exact same message on the app? I did consider rebooting it all but haven’t as yet. Thanks.

Hi Scott, Thanks for the reply. I am only using the master code on the system at the moment.

Thanks for suggestion. I deleted app from both and created code on panel and started app and all started to look good it synced ok and then I confirmed devices and app said ready to use and at the logon stage I logged in and it says the same message about currently being disabled.

I should also mention I have deleted the app reinstalled and generated a new code via the keypad. Thanks

Thanks for the reply. I generated the code form the panel as per the instructions in the app.

Hi All, I attempted to setup the app for the wife and I generated a code fine but the app crashed after syncing bits and now when I try to logon to mine which has worked for months ok we both get “access to this system is currently disabled” The Smartcom is working fine as connecting to Wintex...

Link all fitted and no alerts! Thanks for everyone’s help! Thanks!

Didn’t think so. Weekend it is. Cheers!

I guess this is a silly question but not the first I have asked so will ask anyway. Do I have to power the alarm down to add the wire between Aux and the fault pins? Only ask as want to do it now but the siren is connected to battery now so don’t want it sounding off whilst I do it. Thanks!

Doh, way off the mark there wasn’t I! I assumed it was a wintex change! :-( Perfect explianaton for me! Thanks!!

Is it in here?

Open sorted Zone 8, thanks! Not entirely follow on the AUX Tamper. How do I place a link? Thanks!

Hello, I cannot thank you enough, I now have a working alarm with zones configured. I have a few tweaks I want to make but should be able to sort those with some reading and research! I do have one question though, I have a couple of system alerts that I can’t seem to work out how to clear. I...