Search results

So a combi boiler?

Ok, its live and switched you have, not a Neutral. You have bought a Hive dual channel, what system do you have?

No, the rod screws into the base of the tap and is held by the c shaped metal and rubber washers clamped down with the nut using a monobloc spanner

The switch is likely for the immersion heater(s)

Make sure the plastic “tongue” is sat inside, the mulch piece can’t be left in place, once sat in and over the 2 hooks at the top then the orange flap should then sit nicely...

I don't think that is in properly at the bottom

Yep, Tbf that’s what happened to me as my previous Bosch cut the grass at 20mm and was extremely short near on tearing the grass, the Cleva one once cut sometimes looks like it hasn’t been cut! Not sure what to suggest regards the grass collector.

I have one but mine sits flush. If it's under warranty get in touch, they were really helpful with me. Is it the mulch type and you have the plastic mulch bit fitted?

A leaking diverter will cause the pressure to drop ;)

Ok, doesn't necessarily rule anything out Not really. Dye perhaps if it's heating pipes. Some have said to use cheap aftershave before now, but again only on heating pipes

What’s the other side of the wall?

Apologies, thought it was grey Hep. The part I’ve marked is clearly threaded and should separate, keeping the brass nut in place and connect the isolation valve to that.

No I don't think it's permanent, however not always reusable. Should be demountable. Undo the brass nut just above the plastic coupling and connect the isolation valve there.

Usually poor water quality/detritus in the system.

Kind of what I was asking ;)

So how do you know that the new lever valve isn’t where the fault lies?

So the lever valve is for all flats, not just yours?

So not tested and maybe reluctant to?

It could be a mate of his and as long as it's showing as valid then it shouldn't be a problem. A mate who works with me in social housing has his own registration too. I “replied” to this the other day but it hasn’t posted.

Has the pressure been checked at the lever valve?