Search results

This was removed from our attic, but I would like to know what it was used for? Thanks in advance. Mutley56

I recently changed my aqualisa shower valve. There is a gasket type ring with a filter / strainer that is situated towards the front of the valve. This gasket needs to be orientated correctly so as not to impede water flow. Might be worth checking that. Good luck. Mutley56

Will do at the weekend. Thanks aqua heat

Thanks muggles. Can anyone recommend a good auto stop tap of this type please? Thanks in advance. mutley56

Dear all, An elderly relative has recently started to leave the basin mixer tap turned on and thereby has drained the hot water cylinder on a few occasions. I am thinking of plumbing in a replacement mixer tap that switches off automatically. Can anyone recommend such a tap please? Attached is...

Thanks for the replies. I look at it again tomorrow. Cheers

So if I insert the earth wire into the hole under the screw shown in picture 3, then this will make contact with the earth terminal section shown in pictures 4 and 5 via the small screw head. Does that sound likely and is this the normal way that these fittings are wired up? Thanks in advance...

The whole metal fitting does screw onto the lamp stand

Thanks all, there is an earth terminal in the plastic part as shown is tjis extra picture, I had to bend the copper bit back a bit

dear all, I need to wire in a replacement switched metal BC lamp holder for a table lamp. The lamp stand is metal and needs to be earthed. The lamp holder has a small hole inside with a screw and this is for the earth wire presumably. The other wires screw into terminals on the plastic part of...

A new cartridge it is then. Thanks all Mutley56

Thanks newboy, the handle splines are ok. So it must be the cartridge stop end problem. Does that mean I need a new cartridge? Mutley56

.

Thanks muggles, I am sure that I can find the model, but what is the problem with the tap do you think? It seems like someone has turned it in the wrong direction in the past and now moves more than one quarter of a turn? Thanks for anyone's thoughts on this? Mutley56

hello all, My quarter turn bristan bath cold water tap handle turns more than the quarter turn. So have to turn it both ways to turn the water off. Any ideas on how to repair it / replacement parts? Thank you. Mutley56

Thank you

Hi there. In a sealed system, does the ch system need to be cold before bleeding the radiators or should the system be hot? The boiler controls will be switched off just before bleeding to ensure pump will not start up. I have a system boiler and there is air bubbling in an upstairs radiator...

Many thanks for your replies. That's another job on the list of things for me to do. Thanks again for your help.

duplicated post

Dear all, some rot damage has appeared on the side of a bathroom cupboard where it meets the basin surround. The cupboard was put in 6 years ago. The rot is just above the silicone seal. The panel is made of some type of composite wood material. Any ideas on how to repair it would be...