Search results

That picture is of a power supply the main panel may be the one above

U will have to do a first stage reset which is detailed in the manual which will reset the codes only

U need to find the main control panel for the alarm. The first picture is the remote keypad, the second picture is your MCB. Neither of these have the fuse in that you are looking for. If its on upstairs lighting circuit u may find it in the loft.

The area output may only trigger when armed

What is the output connected to? How are you verifying that the output does not trigger, have you yested the output voltage with multimeter ?

Does the device you are triggering use the same power supply as the alarm ?

What device u trying to trigger..... have u actually tested the voltage on the OP terminal with a multi meter?

When you have switched the jumper pin for the battery over, remove the 12v supply to the bell, if it rings then you do not need to replace the battery.

This is the battery below the red arrow. The battery would only be called upon if there was a total power failure, or if set to SCB

Looks like the battery isnt turned on either... move the bottom jumper pin over to the left

.

I would guess u turn misc 3 options 2+3 on, then set resistor values in option 30

If you are using EOL resistors u need to program this on the panel cant remember which options are required

Can you take a picture of the control panel with the cover removed?

Or change ATE inputs to none in site options if u have eng code

As that is what is causing the fault. Disconnect ribbon cable

Do you have anything connected on the ribbon cable ?

That was for the ones where u could set your alarm, come home and walk around the house without anything activating lol

Looks like it

Yes