Search results

the condensate is in a wall chase which will be behind the dot and dab plasterboard. the condensate will then go in to a 32mm elbow exiting the building through a 2inch cored hole so not on show. So the one side of the 32mm elbow will be well in to the wall. Is this ok, because they won't no...

Is foreverwhite silicone sealant acetoxy cure? Just worried about corrosion to copper?

There is a screed that the pipe will sit on before the insulation is placed on top. Though damp course could be put down so the pipe sits on this

If a gas pipe is ran under a floating floor, under the boards and insulation should it be either coated or taped copper?

Any help?

IMG_20151128_235038 by CAESAR32 posted 29 Nov 2015 at 7:28 PMIMG_20151128_234900 by CAESAR32 posted 29 Nov 2015 at 7:28 PM0014124_savisto-clicker-bath-waste-plug-brass-water-overflow by CAESAR32 posted 29 Nov 2015 at 7:28 PMAny one fitted one of these bath wastes? Struggling to see how the...

Ok theres some white sealant around a pipe and.it has gone abit green

Can silicone sealants corrode copper? I have seen it turn copper green, so is it just corrosive as it is setting?

Or cost guessing its cheaper to wrap then buy with coating?

What do you tend to.Use when encasing a copper pipe in a wall chase coated copper or do you tape with pvc electrical tape with a 50 % over lap just personal preference. I suppose ?

Would could the cause of the heating working but not the hot water on a heat line vizo 24 combi boiler? Guessing divertor valve, dhw flow switch or a sensor. Thanks for any help.

how do over people go about tightening a kitchen tap when swapping one. Is pretty impossible to hold it square while you are underneath with a box spanner? Anyone got any tips?

Thanks so do you set the bath to the correct height for fitting bath panel. Put the bath in place and mark the bottom rim that will sit on to the wood. Remove bath draw a level line around and install wood say 3mm below the line so there's some room for silicone.

Hi, do most people put a timber frame/batten on the wall before installing a bath. To help fix to the wall. Could anyone explain the best way of doing this? Thanks

How does the electrician get away with removing the coater cover to wire up then? Guessing they are not gas safe?