Search results

  1. K

    Fitting new float valve

    I rarely come across a float valve that is a different length, has any thing been moved, like a thicker doughnut washer?
  2. K

    Swapping part 1 for part 2 float valve

    Usually, yes, sometimes older models may have a different thread, you,ll soon see when you dismantle it.
  3. K

    Yorkshire fittings advice please.

    Yorkie fittings are twice the price of end feed, but you choice. You only need a clean, dry pipe to make a good joint, and a smear of flux. Always best to wipe off any excess flux before you solder, and always wipe the joint with a damp cloth after soldering to remove any flux residue. There...
  4. K

    Bath panels vs bath tiles

    Panels everytiome for me, did mine 4 yrs ago, and they look just as good today. As Madrab says, worth paying more for hard backed ones, they're very robust.
  5. K

    Boiler increasing pressure with filling loop disconnected, new boiler same problem.

    Turn off the cold water supply to boiler underneath overnight, if the pressure remains constant, then you will almost certainly have a pin holed plate heat exchanger allowing mains cold water to enter heating system.
  6. K

    HIVE receiver light going off and pump staying on.

    As you have a Worcester boiler, it's most likely that the pump is wired directly to the boiler, rather than from the wiring centre. The idea is that the boiler keeps the pump running for some time after firing to dissipate heat, others will correct me, but I think it runs until a certain temp is...
  7. K

    Compression fitting running above switch

    Not ideal, would prefer soldered joint, but there are millions like that
  8. K

    Filling loop

    It forms part of the non return valve inside.
  9. K

    Advice on gas fire, very confused!

    As long as the fire passes a flue flow, and spillage test, no additional ventilation is required, as the heat input is less than 7kw.
  10. K

    Mystery combi boiler issue?

    If the display reads 00 then it hasn't got a call for heating from the themostat?programmer.
  11. K

    Ideal Logic System 24 Filling Loop Location?

    Part costs £48, 5 min job to change
  12. K

    Ideal Logic System 24 Filling Loop Location?

    My money would be on blocked condensate pipe/trap, or spark generator, you'll need a gas man in for those.
  13. K

    Broken basin waste nut

    Those plastic things are pants, change it for a brass one.
  14. K

    Cystern inlet valve

    Probably just one of those things, just bite the bullet and change the whole valve, they're not expensive.
  15. K

    Radiator Valve Fitting Back to Front?

    You can buy "corner valves" for that, they look much neater
  16. K

    Banging combi, but it's off!

    Does it continue if you isolate the cold feed to the boiler?
  17. K

    Port valves - which ones should I use?

    I've used quite a few ESi valves, have had no issues with them. Yet
  18. K

    Toilet Lever Lose

    How did you lose it?
Back
Top