Search results

pinks softer

check the safety bo pipe which discharges outside

try uk spares

Probably lime scale build up in ht exchanger

think she was a he nurse :oops:

was she offering the sex to all 3 of you naughty boys :D

now thats a telling off :shock:

You could stick it to the wall with plaster or even tile adhesive ensuring the wall is perfectly flat. If the wall is uneven then chase the plaster around the surround etc first and then plaster it back in. Yes you want some morter between the head and legs for which you could use coloured...

Buy a new pop up from b&q, take out the bit you need (think there all the same) and take the waste back for refund. :lol: Dont worry plumber who has to fit it second time round wont mind, :x esp when hes on a price to fit it and the customer has supplied the waste. Thats the kind of c r...

Not always the case. May be to prevent pump running until temperature is high enough in the boiler to prevent condensation in boiler.

did it go bang :shock: cus you dont wire the n/o to the incoming neautral supply n/o means normally open. pipe stats dont have neutral connections. neautral to pump neutral live to common on stat n/c or n/o to live on pump depending on what you want it to do

Did i say 2 minutes, opps, ment 2 hours

Not wishing to be tooooooo sarcastic newoilman but by the fact youve just been to............blah blah blah, this is for a paying punter and you have to ask questions on a forum to fix a boiler which quite clearly you havnt the faintest idea what your doing :?: yes obviously the photcell...

Only thing stops me sleeping are the 3 kids :cry:

Must be slacking :lol:

Is this down to bad experiances? I didnt think they were much different to the plus's. Ive been fitting quite a few for landlords recently. Doh! been fitting pros not exclusives :roll:

Most likely diverter valve, 2 minute job to fix :wink:

like they have for the last 50yrs before some jobsworth made them over safe

Often overheat of immersion is caused by the primary heat source heating the water hotter then the oh stat is set to. For example if the cylinder is connected to a rayburn. If this is the case just bypass the oh stat

Presume you checked the expansion vessel