Search results

485 coms lost is a loss of data to the keypad which is displaying the message. Usually a cable issue on remote keypads, If its the main panel on the enforcer then I guess it would indicate a faulty panel.

A well installed system should never false alarm, I think you should look at your detection equipment first and the way its sited in relation to the manufactures instructions. A switch wont turn off whist your away if it false alarms & could be switched off by mistake or even worse switched...

Take off PIR lid and silence tamper alert, replace battery then reset system.

Yes your right.

You need a long drill bit (1/2meter long by 10 or 15mm in diameter) place drill bit in the corner of the coving and the drill bit will flex to your advantage, drill up horizontally, your first go through the coving then the ceiling, once through drill back out and thread cable up. Retrieve cable...

Press and hold D until it asks for security code, enter 2000 press yes to go through menu and your see keypad volumes. Press A to esc... And yes ideally a 16ohm speaker for all your entry exit tones.

Look whats wired into the AUX Tamper terminals on right side of Panel PCB, usually the internal speaker tamper. Place a link of wire to bypass if not required. Then 0 + ESC should then say Open then Time display.

In that case your have to prog the output to function to do only one of the following: Alarms : Siren Any Or Entry Exit tones: Entry Exit A 16ohm speaker would work better here imo.

Yeah neg to neg and pos to pos will, this is what i suggested to test it. You dont want it making a noise all the time hence the neg goes into the o/p on keypad. I presume this should work as your expecting it too.

PRG on keypad to Neg on sounder + on keypad to Pos on sounder

Ok, test the sounder by wiring in the + into keypad and tapping the neg on the normal neg terminal, this should produce sound, move the neg wire into the keypad output and test. Let us know what happens? What sounds are you after, alarms only, entry exit only or both?

What sounder are you using? If its a 16ohm speaker cone type then wire into Keypad OP and +, leave output programmed as 0000 (not used) -no programming required.

Engineer menu > Assign Keypads/Readers > Keypad 0 > enable A& B (same for any other keypads)

Enginner mode > Setup Users go to each individial users attributes & your see *****C Press '6' to take away the 'C' on each user.

In Zone Setup go to the front door circuit setup, go to its attributes and enable "Guard" that will give an instant alarm on part set and a timed entry in full set. Atributes 1 *******G

Keep Hardwired, Only go for a system with an LCD keypad (displays full text on screen) and go with a reputable brand such as Pyronix (Euro Mini/ Euro 46), Texecom (Veritas Excel/Premier Elite 24) Honeywell (Galaxy flex) or Scantronic (9448) Some of these have an app too, giving you full control...

Multiple incorrect keypresses at device 0 which is the onboard keypad.

Who's selling it, cant find a supplier?

Think you can replace the leaf switch on those, we have a custom made PCB & assembly at work so not entirely sure on the mass market ones.

If your getting Siren Tamper then you really need to check the siren again or replace it, Clean starting will not solve anything. The siren has a screw next to the tamper switch which presses against the wall, by turning the screw the leaf switch comes out towards the lid, make sure you hear...