Search results

Make sure it’s clear of the side of the cistern and is it adjusted to the correct level?

I think that looks like one of the newer ones, if so, then it’s fine. The older types had the cover sealed all the way across. If the pcb housing is fine and the cover forms a seal all the way around the outer edge then it’s fine. They’re only classed as At Risk as there’s no current danger...

Unless it has voltage reading capabilties then please dont as theyre useless for what you need. To be fair, this (in your opening post) shows terminals but further photos do not

I have changed lots of stuff too (gas engineer) and have easliy got distracted or whatever and when confirmed voltage it hasnt been correct.

Maybe go and buy a cheap tester? Or employ an electrician? Unless you can confirm correct voltages, I doubt wiring advice would be beneficial.

Any photos of existing ones? Maybe type this into a search engine? upvc screw hole covers

Maybe this is of some use? https://electrical.theiet.org/wiring-matters/years/2019/75-may-2019/to-bond-or-not-to-bond/

Private or social housing landlord? If the latter point them towards Awaabs law, Riddor and COSSH if the former then probably just COSSH and Riddor.

I think they could be correct, probably just the orientation, for which they cannot assume where the hole will end up

Yes the last photo appears correct, but I can’t find the instructions online, could you post a photo of the bit you mention?

It looks to me like the fill valve is catching on the cistern.

Ime, it’s usually the float valve passing water via the internal overflow, not the actual syphons.

Not entirely sure, but it's either a slight turn and lift off or just lift off. Maybe this can help?

Definitely a fill valve, not the syphon

Pre soldered (possibly Solder ring you’re thinking of) need the pipe clean, fluxed, clean of dirt/debris et al, no water in the pipe and heat applied.

Salvageable imo. Might need a new back rail, but ultimately looks like the condense hose has failed (common on this year/model), it even looks like it’s not attached and, if that’s the case, then your boiler man should have turned the boiler off and issued a do not use sticker and warning...

I only saw a bit of it last night. There seemed to be some bias towards Uraguay, and there seemed a lot of shoving. Uraguay deserved a conceded goal after that GK blunder - was it David James in goals? :ROFLMAO:

Au contraire https://www.plasticpipeshop.co.uk/75mm-2-12-Grey-PVC-Pipe-10-bar-PN10-25m-Length_p_5317.html, just ain’t cheap!

Your last photo shows a white cowl, which is an air admittance valve - can this be swapped with your proposed stack?

Yes it can be reduced in size to not less than 75mm for single or 2 storey properties. Or perhaps change the air admittance valve on the other one for the 110mm on existing and vice versa.