Search results

I'm no expert, I've just seen it on the packaging/instructions for LVT. It might be that click LVT is a floating product and heavy appliances could pin it down preventing expansion.

If this is going in a kitchen think about heavy appliances like washing machines and fridge freezers which may cause problems with click LVT.

Where does the waste pipe go when it gets outside? Photo?

Trample with feet and then spray.

Unfortunately the wiring in the ceiling rose has also been changed by the OP. Exactly this.

Not very much. I might be slightly easier to tighten it into position with it set on Max. You have a few choices offered by people in this thread: 1. Cheapest & quickest - Get a new head and screw it on. 2. Better, a little more expensive, but should provide a longer term fix - Replace the...

Out of interest, because I'm going to have to try to reseal my own conservatory roof, how do you gain access to the ridge? I cant reach the ridge from a stepladder and I don't know how much weight I can put on the bars that support the Polycarbonate roof sheets Do I try to slide a...

You could if it's big enough. Walls tend to wiggle a bit, corners are not square and straight bits are not straight. I usually put a large sheet of plywood, chipboard or mdf along the wall and measure the worktop dimensions and angles from that.

You should not be able to see any copper here: Turn off the power, loosen the screw and shove the copper further into the fitting (you may need to cut a little off the end of the copper to get it to go in).

There will be a section through the building, shown separately on the plans, labelled "Section C" which shows you a view through the building at that position.

The piece of timber that I can see in the centre of my red shape drawn on your photo, underneath the lead flashing, will get wet when it rains. That will eventually cause it to rot. The water will also run onto whatever lies below that timber. I can see a shadow between the two pieces of lead...

The biggest problem that I can see is here: Tile broken with half of it missing, poor leadwork, visible timber under the lead flashing. The dry verge isn't great at that location either. Most of your light in the loft seems to be coming from ventilated eaves which is expected.

You might find a white funnel intended for the job in the glovebox or with the spare wheel/jack. A funnel would have been supplied with the vehicle when it was new.

Perfect.:rolleyes: It's white which will look lovely against the brickwork and black pipe and it's for interior use only so it should hold until the next time it rains.

They are being used outside. :giggle: On a serious note they are fitted to the wheels the wrong way round. They need to be refitted to the wheels so that the "outside" marks are on the outside surface. The other two may be ok. Only asymmetric tread patterns have the "Outside" marks.

He did that in 2023. I expect the OP has managed to change the battery by now or has purchased a replacement programmer.

They are intended to fill up (some of) the cavity so they shouldn't stick out.

Most petrol stations have covers over their forecourts so that you don't have to stand in the rain whilst filling up. Most public EV charging stations have no covers so you get wet whilst plugging in.

Yes, which is not too helpful as it make me look like a bigger nutter than I actually am. :rolleyes:

I expect that some time in the more than 22 years since the OP had this problem they will have found a solution or changed their vehicle.