Search results

As above old sensors can cause this and also low batteries in local wireless devices. Another cause of jamming is newly installed LED street lights. turn wireless jamming to 000 and have done with it.

Yes it will work as a stand alone bells only system. You’ll need to disable the communications inside the engineer menus.

I second the method of deleting the first expander and relearning all onto the 32 way. We have had a couple of sites where the supervision issues are constant on two 8xp, swapped them for a 32 and no more problems fully meshed

CSL Dualcom

Easiest method is using smart device then any character of the password can be input

If the system is maintained then surely you can get your security company out to remove the SMS feature for the time being?

The jumpers in the picture aren’t across both pins for resistance…

We use 8core and double up on 12v + -

I thought they auto-learn as a MASTER type

As sparky said re-program, Wintex won’t allow you to send premier data to an elite panel it’s conflicting.

The screw shouldn’t be an issue, unless you’re getting a tamper fault. Did you do a bell test following replacing the battery? I’d be inclined to delete the bell from the system and re-learn

I think key 1 does some characters but not everything . - / off the top of my head

If your installer can’t see any requests for phone authorisation then I’d suggest double checking your System ID is correct in the app. Be careful of the 0/Os and 1/Is

Static IP address will allow for sped up playback on ProControl. Other than it it’s setting up a DDNS to log into the NVR which would also allow the sped up playback

Have you programmed the OP3 as bigsosij recommended earlier?

no aux fuse to pull on a 9651, but I agree wouldn’t bother down powering you have two 12v aux outputs so should be plenty of room to get the cables in

Shocks require a 12v aux feed, so should have a pair wired into the zone and a 12v feed from AUX

This… heavy handed screwing of the tamper back plate is 9 times out of 10 tamper problems on DC

This one is painful

NVR output mode may need adjusting , can you test it on VGA output?