Search results

Is this it? https://pipescenes.co.uk/shop/toilet-spares/fill-valves/1-2-side-entry/1-2-side-entry-toilet-cistern-water-inlet-float-valve-for-wye-concealed-cistern/ Same available online but way more in price? Malta MK2 Internal Inlet Float Valve R54SP87141173545 OFC24 EDM42 - Bepoke Part £56.80

This has come up before but we have plenty of power as is. You can view power generated and used on national grid website. https://grid.iamkate.com/ Solar is doing well ATM.

Kill Moss. Ventilation either end of garage so you don't get condensation. You might need some insulation to stop the mould... Need more information to get you a better answer

Some things to consider. I think have one or two on one switch for winter evenings when you just want a little light vs get tanned. Normally put in corner. As for the rest. It's nice to have a symmetrical room but practically that just doesn't work sometimes. You end up with light where you...

Id remove. Get a single pain cut. Fit Putty up Paint. Stick new lead to glass to make it like a 4 pain window. Why complicate it. DIY person could do that without much difficulty

Is that a single pain of glass with the lead stuck on? It's not 4 separate pains?

Yes a warning light is a fault thrown up on management system which is a mot failer. You don't know if that is a major or minor fault. Maybe that's where the confusion is. Ask garage to look at it first then decide how to proceed.

It's not lime your painting over. It's distemper. Lime plaster is fine you have the correct paint. Not the distemper though

No. It won't stick. You needed to wash off the old distemper. Look up the oil-bound distemper data sheet. Whats the advice on that?

https://amzn.eu/d/051ThxGx Reading up it's a match but check hole alignment..

Sand off dispenser is easiest. Bodge a cheap DIY orbital sander on a vacuum with 120 grade disc. Other way is to wash it off but a horrible job. Worst thing is to try and paint over it as that's a problem now. You need to scrape off paint and remove the distemper

You want knot free pressure treated timber. Local timber merchant yard is what you want. Go look at what they have that will do it. Get advice there.. I built pergola and some garden furniture. That's what I did and got them to deliver. I have a few around me and one builds gates to spec...

Find a timber merchant and get a price. They will cut to correct size. You want treated external timber

Don't cut skirting. It's a right pain to fill and will give you a job. Best way is to remove skirting and run behind and the wall could you chase out? Plasterboard or brick?

£12.50 on Amazon. Assuming I'm looking at correct part. Fact check me

There is silica in the outside of window all the way around that gets saturated eventually so that maybe leaking moisture back inside pain. Water will form inside. Also it's high humidity in the air as car is wet every morning. Physics question I guess

If you buy panther 5lt paint stripper it's not ment for DIY market and it's the good stuff vs the smaller tins for DIY. That's what I've been told. Try that maybe

You can buy repair bitumen ect. Always use the primer if it advises. You can use masking to keep area clean as it can get messy. Just remembered patching isn't always the best nor will it last.

Felt it not an option? I know rubber roof it a good option if you can stretch.. Patching isn't the best

Insulated plasterboard. Cheaper to buy something's like kingspan and stuck on. Then stick on plasterboard. Use polymer grab like stixall or foam or both as a glue. Layer it to make depth