Search results

For a temporary option, try searching for a freestanding stainless-steel catering or utility sink, as these are usually deep and fairly easy to move. When you’re ready for a fitted version, a standard base unit with a deep sink would look much neater. MonoLux Worktops has produced a similar deep...

That makes sense and confirms the unsupported section of laminate was allowing the front-left foot to move during spinning. The plywood has now given all four feet a firm, consistent base. If it stays level and doesn’t move or vibrate excessively over the next few washes, it sounds like the...

That suggests the movement was caused by the floating laminate flexing or sliding rather than a fault with the machine. The plywood has created a firmer base, but keep an eye on the surrounding laminate because floating floors need room to expand and screwing them down can sometimes cause...

The line may be caused by uneven sanding or oil absorption, while the black knot could be staining from moisture or a reaction within the timber. I wouldn’t apply any more oil yet. Ask the worktop supplier to inspect it and confirm whether it can be sanded back and refinished. The entire sink...

That level of chipping and poor scribing across most of the units isn’t normal for a professionally fitted kitchen. Take clear photographs of every issue and send the joiner a written snagging list, asking them to inspect and correct the work before making any final payment. Damaged doors...

A 1,000 W microwave would normally use a standard 13 A socket, so a dedicated 20 A supply sounds unnecessary unless the manufacturer specifies otherwise. The oven and hob may be able to share the cooker circuit using diversity, but that depends on the cable, protective device and manufacturers’...

First, check that all the transit bolts were removed during installation and that the machine doesn’t rock when you press down on each corner. Also make sure the laundry is evenly distributed, as a single heavy item can cause severe movement. If those checks don’t help, stop using the spin cycle...